-
(Table XXXV, pages 238-241) Chemical composition of nodules from the Atlantic...
The H2O is determined by air-drying the nodule samples at 200°C for two hours. The loss on ignition (LOI) is then measured after a one hour heating at 1100°C. In reducing the... -
(Table 2) Summary of index properties at DSDP Hole 75-532A
This dataset has no description
-
(Table 2) Physical properties of sediment at DSDP Sites 87-582, 87-583, and 8...
This dataset has no description
-
(Table 5) Major- and trace elements at DSDP Hole 89-462A
This dataset has no description
-
(Table T1) Ex-situ consolidation properties of sediments from ODP Leg 207 sites
Depth, sediment is given in mbsf. -
(Table 1) Index properties of ODP Leg 110 triaxial samples
This dataset has no description
-
Index properties of sediments from ODP Hole 101-630B (Table 2)
Three holes were cored at Site 630 during Leg 101 of the Ocean Drilling Program. Whole-round samples were obtained for geotechnical analyses from Hole 630B. Consolidation... -
(Table XXX, pages 182-221) Chemical analyses of manganese nodules and crusts ...
The H2O is determined by air-drying the nodule samples at 200°C for two hours. The loss on ignition (LOI) is then measured after a one hour heating at 1100°C. In reducing the... -
(Table 1, page 1376) Chemical analyses of manganese nodules and crusts from t...
A compilation of chemical analyses of Pacific Ocean nodules using an x-ray fluorescence technique. The equipment used was a General Electric XRD-5 with a tungsten tube. Lithium... -
(Table 2) Sediment physical properties at DSDP Leg 72 Holes
This dataset has no description
-
(Table 1) Index physical properties for consolidation samples of ODP Sites 16...
This dataset has no description
-
(Table 2) Geochemistry for clasts extracted from DSDP Site 89-585 debris flows
This dataset has no description
-
(Table T37) Ko-consolidated undrained test conditions and properties of undra...
All stresses / pressures were originally measured in ksc (kgf/cm**2). The conversion of ksc to SI units is 1 ksc = 98.07 kPa. -
(Table T36) Ko-consolidated undrained test conditions and consolidation prope...
All stresses / pressures were originally measured in ksc (kgf/cm**2). The conversion of ksc to SI units is 1 ksc = 98.07 kPa. Test samples TX641, TX644, TX647 and TX650 were... -
(Table T17) Constant rate of strain consolidation test conditions and consoli...
All stresses / pressures were originally measured in ksc (kgf/cm**2). The conversion of ksc to SI units is 1 ksc = 98.07 kPa. Test samples CRS499 and CRS577 were omitted because... -
Tab. 3: Chemical composition of saline lakes in the Dry Valley region
This dataset has no description
-
Tab. 2: Chemical composition of saline lakes in the coastal region
This dataset has no description
-
(Table 1) Index properties of ODP Leg 112 samples
This dataset has no description
-
(Table 1) Physical properties of Norwegian Sea sediments
This dataset has no description
-
(Table 2, page 1177) Composition of manganese deposit samples from Cuba
Todorokite is a very abundant manganese oxide mineral in many deposits in Cuba and has been noted from other localities. Six new analyses are givenl they lead to the approximate...